Zepoxy LEEG 10 Epoxy Regin Grout Grouting Heavy Machinery Base Plates Ccompressors Generators Turbines in Pakistan

Zepoxy LEEG 10 Epoxy Regin Grout Grouting Heavy Machinery Base Plates Ccompressors Generators Turbines in Pakistan

Packing

25 KG total pack
Part A: 10 KG
Part B: 05 KG
Part C: 10 KG

Zepoxy LEEG-10 is a solvent free, three component, free flow epoxy grout designed for mass grouting. Due to its low exothermic reaction, it is particularly suitable for grouting at high ambient temperatures.

Zepoxy LEEG-10 can be used for grouting heavy machinery base plates, compressors, generators, turbines, centrifugal pumps, bolt pockets, Crain rails, bridge bearing, stanchion (Steel column) base plates reprofiling-waterproofing of pile and areas where rotary / reciprocator movements are encountered. It is used as a grout media to transfer dynamic load effectively. Ideal for chemical plants, refinery, oil and gas, water industry and structural encasing

Application 

Prepacked, ready to use.
Solvent free, no shrinkage.
High mechanical strength.
Can be used for 30mm to 300mm in a single layer without generating excessive exotherm.
Curing is not affected by high humidity.
Impact and vibration resistant.
Good chemical resistance.
Good adhesion to most of the surfaces.

Surface Preparation 

All surfaces should be dry, clean, free from standing water, grease, curing compounds, mold oils and all loosely adhering particles. Cement laitance should be removed by mechanical means. Roughen surface with chipping to ensure good bonding. Steel surfaces must be clean and rust free.

Mixing

Mix base and hardener roughly with a slow speed drill (Max 400 rpm) for 1 minute in a suitable container. Add filler component slowly and continue mixing until a flowing uniform color is achieved.

Formwork

The formwork should be watertight. Sealant can be used to seal gaps between formwork and the concrete, as well as joints in the formwork. Alternatively, a suitable plugging material can be used to fill the gap between formwork and concrete.

Application

Place the mixed grout within the pot life of the product. Bolt pockets should be glued first. Stop the grout 5mm to 10mm below the top surface of the bolt pocket. Grouting of the base plate should be carried out continuously. Ensure to have enough grout in place prior to starting. Start pouring the mixed grout from one side of the formwork to prevent entrapping of air.

This can be achieved by pouring the grout to the shortest distance. During application ensure entrapped air is released through relief holes. Maintain continuous head during the grouting. Grout flow should be interrupted. Check for any grout loss through the form work or between unsealed joints. Plug the same using a suitable water plug. For difficult voids a metal strap or chains may be used to assist grout flow.

At Pakistan Power Tool keeping the pace of industry developments, we have an extensive range of Ressichem Dry Mix Mortars Premix Plasters Ressichem Building Care Maintenance Tiling Grouting Materials available at best competitive rates in Karachi, Lahore, Islamabad, Rawalpindi, Peshawar, Quetta, Multan, and all over Pakistan.