Ressichem Ressi TA 280 Flame Retardant Crack Resistant Dry Premix Cement in Pakistan

Ressichem Ressi TA 280  Flame Retardant Crack Resistant  Dry Premix Cement in Pakistan

Ressi TA 280 is a dry premix ready to use cement based insulating and acoustic tile adhesive containing perlite, aggregates, and other polymers.

Ressi TA 280 can be used for standard tile bonding application for internal and external floor and wall tiling. Ressi TA 280 is an ideal tile adhesive for installing mosaic, ceramic, and other general homogenous tiles. Ressi TA 280 can easily be applied using the application spectrum as defined by BS EN 5385-1.

Advantages

Aids in insulation.
Flame Retardant.
Aids in sound Reduction.
Crack resistant.
Longer open time.
Salt free mix.
Excellent workability.

Surface Preparation

All loose particles and oil shall be cleaned off the surface prior to the application. For very hot climatic conditions, the surface may be dampened with potable water. Application on most type of cementitious surfaces like block work, concrete and rough plastered surfaces is possible.

The surface should be sufficiently aged (At least 7 days for newly erected masonry surface and freshly plastered surface) before the installation of the tiling may begin. It is also recommended that expansion joints should not be tiled over, and suitable treatment should be done over them. Highly absorbent surfaces should be dampened before spreading Ressi TA 280. 

Defective and unsound surfaces should be repaired before the installation of the tiles. It is also important to ensure that there is no dust at the backs of the tile, otherwise it may cause hollow sounds and improper adhesion of the tiles to the substrate.

Product Preparation

It is important that water is premeasured in accordance with the amount of material used. The Mortar powder should be added over the water to avoid the settlement of the material at the bottom of the mixing container.

The Mixing container should be uncontaminated, non-corrosive and clean. Only potable water should be used for mixing. It is also recommended that the material should be mechanically mixed with a mortar mixer or other mechanical mixing methods to obtain a consistent lump free mix.

Application

Buttering of the material onto the back of the tiles is usually not recommended as it this may cause poor adhesion. Spread the material evenly onto the surface using a suitable straight edge trowel and then notch immediately.

To ensure good bonding, it is recommended not to spread the material more than 1m2 at a time as the mortar may dry up resulting in poor adhesion and causing difficulties in application. After the application and levelling of the mortar, the tiles should be firmly knocked into the position. Adjustment of the tiles should be done at a maximum of 15 minutes after application.

At pakistan power tool keeping the pace of industry developments, we have an extensive range of Ressichem Dry Mix Mortars Premix Plasters Ressichem Building Care Maintenance Tiling Grouting Materials available at best competitive rates in Karachi, Lahore, Islamabad, Rawalpindi, Peshawar, Quetta, Multan, and all over Pakistan.